Dell POWEREDGE M1000E - Manual (Page 834)

812 Fabric OS Message Reference
53-1002749-01
SSMD-1007
5
SSMD-1007
Message Error while removing ACL <ACL name> from interface <Interface name>.
Message Type LOG
Severity ERROR
Probable Cause Indicates that an error occurred while programming a TCAM entry on the specified interface.
Recommended
Action
Try again after some time. If the problem persists, execute the supportSave command and then restart
or power cycle the switch.
SSMD-1008
Message Apptype TCAM Table full for Slot:<slot number> chip:<Chip number in the slot>.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the application type TCAM table is full on the specified chip.
Recommended
Action
Remove the unused protocol-based VLAN classifiers and Layer 2 extended access control lists (ACLs).
SSMD-1200
Message
QoS failed programming ASIC <ASIC slot number>/<ASIC chip number> Multicast Rate
Limit.
Message Type LOG
Severity WARNING
Probable Cause Indicates that DCE SSM encountered an unexpected error in programming the dataplane
application-specific integrated circuit (ASIC) for enforcing the Multicast Rate Limit feature.
Recommended
Action
Delete and reapply the Quality of Service (QoS) Multicast Rate Limit policy using the qos rcv-queue
multicast rate-limit command.
If the problem persists, restart or power cycle the switch.