Dell POWEREDGE M1000E - Manual (Page 439)

Fabric OS Message Reference 417
53-1002749-01
FICN-2085
5
FICN-2085
Message FICON or FCP Emulation Enabled FCIP Tunnel is Up on VEPort=<VEPortNumber>.
Message Type LOG
Severity INFO
Probable Cause Indicates a FICON or Fibre Channel Protocol (FCP) emulation-enabled FCIP tunnel has been
established successfully to the peer switch.
Recommended
Action
No action is required.
FICN-2086
Message FICON or FCP Emulation Enabled FCIP Tunnel is Down on VEport=<VEPortNumber>.
Message Type LOG
Severity ERROR
Probable Cause Indicates a FICON or Fibre Channel Protocol (FCP) emulation-enabled FCIP tunnel to the peer switch
has been terminated.
Recommended
Action
This is an unexpected event; contact your vendor's customer support for assistance.
FICN-2087
Message FICON connected 3900 printer discovered Path=0x<VEPortNumber HostDomain HostPort
DeviceDomain><DevicePort LPAR CUADDR DeviceAddr>-invalid compression mode.
Message Type LOG
Severity ERROR
Probable Cause Indicates that FICON Printer emulation is enabled, but cannot be performed for this device because the
compression mode on the tunnel is not set to None or Aggressive.
Recommended
Action
If you desire FICON Printer emulation for this device, modify the tunnel compression mode to None
(mode 0) or Aggressive (mode 3).