Dell POWEREDGE M1000E - Manual (Page 219)

Fabric OS Message Reference 197
53-1002749-01
C3-1012
5
C3-1012
Message S<slot number>,P<port number>(<blade port number>): Link Timeout on internal port
ftx=<frame transmitted> tov=<real timeout value> (><expected timeout value>)
vc_no=<vc number> crd(s)lost=<Credit(s) lost> complete_loss:<Compless credit
loss>.
Message Type LOG | FFDC
Severity CRITICAL
Probable Cause Indicates that one or more credits have been lost on a back-end port, and there is no traffic on that port
for two seconds.
Recommended
Action
Turn on the back-end credit recovery to reset the link and recover the lost credits. If credit recovery has
already been turned on, the link will be reset to recover the credits and no action is required.
C3-1013
Message Multi RDY/Frame Loss detected on Slot <slot number>, Port <port number>(<blade
port number>) m_rdy(0x<Multiple Credit(s) Lost>)/m_frame(0x<Multiple Frame(s)
Lost>).
Message Type LOG
Severity WARNING
Probable Cause Indicates that wait cycles to recover the lost frame or credit are exceeded on the specified port.
Recommended
Action
Turn on the back-end credit recovery to reset the link and recover the lost credits. If credit recovery has
already been turned on, the link will be reset to recover the credits and no action is required.
C3-1014
Message Link Reset on Port S<slot number>,P<port number>(<blade port number>) vc_no=<vc
number> crd(s)lost=<Credit(s) lost> <Source of link reset > trigger.
Message Type LOG
Severity WARNING
Probable Cause Indicates that one or more credits were lost and the link is reset.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.