Dell POWEREDGE M1000E - Manual (Page 745)

Fabric OS Message Reference 723
53-1002749-01
SEC-1145
5
SEC-1145
Message A security admin event has occurred. This message is for information purpose only.
The message for individual event is: <Event specific data>.
Message Type LOG
Severity INFO
Probable Cause Indicates one of the following has occurred:
• The names for the specified policies have changed.
• The passwords have changed for the specified accounts.
• The SNMP community strings have been changed.
Recommended
Action
Verify the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security policy.
SEC-1146
Message
PID changed: <State>.
Message Type LOG
Severity INFO
Probable Cause Indicates the PID format of the switch was changed either to extended-edge PID or from extended-edge
PID. If the Device Connection Control (DCC) polices existed, all index/area ID values either increased or
decreased by 16. The values wrap around after 128. If a DCC policy contains an index/area of 127
before changing to extended-edge PID, then the new index/area is 15, because of the wraparound.
Recommended
Action
No action is required.
SEC-1153
Message Error in RCA: RCS is not supported.
Message Type LOG
Severity INFO
Probable Cause Indicates that reliable commit service (RCS) is not supported.
Recommended
Action
Run the rcsInfoShow command to view RCS capability on the fabric. RCS must be capable on all
switches in the fabric to be enabled. If all switches are capable, it is automatically enabled.
For any switch that does not support RCS, obtain the latest firmware version from your switch supplier,
and run the firmwareDownload command to upgrade the firmware.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.