Dell POWEREDGE M1000E - Manual (Page 639)

Fabric OS Message Reference 617
53-1002749-01
MS-1001
5
MS Messages
MS-1001
Message MS Platform Segmented port=<port number> (0x<port number (hex)>) (<reason for
segmentation> <domain> (0x<domain (hex)>)).
Message Type LOG
Severity WARNING
Probable Cause Indicates that the Management Server (MS) has segmented from another switch domain at the specified
port because of errors or inconsistencies defined in the MS platform service.
Recommended
Action
Reboot or power cycle the switch.
MS-1002
Message MS Platform Service Unstable(<message string><domain number>).
Message Type LOG
Severity INFO
Probable Cause Indicates that the Management Server (MS) platform service is unstable.
The message string value can be one of the following:
• No Resp for GCAP from: The switch did not respond to a request for a GCAP (MS Get
Capabilities) command.
• GCAP sup but not PL by: GCAP is supported but the flag for MS platform service is not set.
• GCAP Rejected (reason =BUSY) by: GCAP is not supported by another switch.
• Reject EXGPLDB from: The request to the exchange platform database was rejected. The
remote switch may be busy.
The domain number is the target domain that caused the error.
Recommended
Action
The recommended actions are as follows:
• No Resp for GCAP from: No action is required.
• GCAP sup but not PL by: Set the flag for the MS platform service.
• GCAP Rejected (reason =BUSY) by: Execute the firmwareDownload command to upgrade the
firmware level on the switch to a level that supports reliable commit service (RCS). RCS is
supported in Fabric OS v2.6, v3.1 and later, and v4.1 and later.
• Reject EXGPLDB from: Wait a few minutes and try the command again.