Dell POWEREDGE M1000E - Manual (Page 316)

294 Fabric OS Message Reference
53-1002749-01
EM-1067
5
EM-1067
Message Stopping synchronization of the system due to <version> incompatibility with
standby CP.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the software version on the standby control processor (CP) is incompatible with this
software feature enabled on this Fabric OS firmware version.
Recommended
Action
Upgrade the software on the standby CP or disable the software feature on this CP.
To disable the Ethernet switch service, execute the fosconfig --disable ethsw command.
To view the buffer optimization mode for the slots, execute the bufopmod --showall command, and then
execute the bufopmode --reset slot command to disable the feature for those slots before downgrading.
To disable FC8-16 Serdes tuning mode, execute the serdestunemode --reset command.
EM-1068
Message High Availability Service Management subsystem failed to respond. A required
component is not operating.
Message Type FFDC | LOG
Severity ERROR
Probable Cause Indicates that the high availability (HA) subsystem has not returned a response within four minutes of the
request from the environmental monitor (EM). It usually indicates that some component has not started
properly or has terminated. The specific component that has failed may be indicated in other messages
or debug data. There are serious internal Fabric OS configuration or hardware problems on the switch.
Recommended
Action
Restart or power cycle the switch.
If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
EM-1069
Message Slot <FRU slot number> is being powered off.
Message Type LOG
Severity INFO
Probable Cause Indicates that the blade in the specified slot is being intentionally powered off.
Recommended
Action
No action is required.