Dell POWEREDGE M1000E - Manual (Page 387)

Fabric OS Message Reference 365
53-1002749-01
FCR-1072
5
FCR-1072
Message Port <port number> is changed from FCR port to non FCR port.
Message Type LOG
Severity INFO
Probable Cause Indicates that the port is no longer an EX_Port or VEX_Port.
Recommended
Action
No action is required.
FCR-1073
Message Switch with domain ID <domain ID> in fabric <fabric ID> has lower limit of LSAN
Zones supported.
Message Type LOG
Severity INFO
Probable Cause Indicates that an older version switch in the backbone or edge that supports a different limit of logical
storage area network (LSAN) zones was detected.
Recommended
Action
Use the fcrResourceShow command on all Fibre Channel Routers in the Meta-SAN to find lowest
supported LSAN zone limits. Ensure the total number of LSAN zones in the Meta-SAN are within the
lowest supported limit of LSAN zones.
FCR-1074
Message HA sync lost as remote CP supports only <LSAN Count> LSAN Zones.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the remote control processor (CP) has older firmware, which supports a lower number of
logical storage area network (LSAN) zones. This is causing the loss of high availability (HA) sync.
Recommended
Action
Keep the number of LSAN zones to the lower limit of the two CPs or upgrade the remote CP.