Dell POWEREDGE M1000E - Manual (Page 365)

Fabric OS Message Reference 343
53-1002749-01
FCPH-1001
5
FCPH Messages
FCPH-1001
Message <function>: <failed function call> failed, out of memory condition.
Message Type FFDC | LOG
Severity CRITICAL
Probable Cause Indicates that the switch is low on memory and failed to allocate new memory for a Fibre Channel driver
instance.
The function value can only be fc_create. This function creates a Fibre Channel driver instance.
The failed function call can only be kmalloc_wrapper, which has failed. This function call is for kernel
memory allocation.
Recommended
Action
A non-bladed switch will automatically reboot. For a bladed switch, the active CP blade will automatically
fail over and the standby CP will become the active CP.
FCPH-1002
Message Port <Port Number> has been disabled since switch requires authentication when
device authentication policy is set to ON.
Message Type LOG
Severity WARNING
Probable Cause Indicates a device that does not support authentication has tried to log in to the switch when the device
authentication policy is in ON status on the switch.
Recommended
Action
Enable the authentication on the device or set the device authentication status to PASSIVE/OFF on the
switch if it is not mandatory. Use the authUtil command to change the device authentication policy.
FCPH-1003
Message New port <Port Number> has same Port WWN as old port <Port Number> as part of
duplicate Port WWN detection policy.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the specified new port has the same Port World Wide Name (PWWN) as the old port.
Recommended
Action
No action is required.