Dell POWEREDGE M1000E - Manual (Page 311)

Fabric OS Message Reference 289
53-1002749-01
EM-1047
5
Recommended
Action
If the blade ID listed is incorrect, the field-replaceable unit (FRU) header for the blade is corrupted and
the blade must be replaced.
If the error is due to the platform, the blade ID listed is not supported for that platform (CP) type. Remove
the blade from the chassis.
If the error is due to the backplane, the CP type (CP256) is not supported on that chassis (backplane
revision D2). Remove the blade from the chassis.
If the error is due to the switch configuration, the logical switch configuration of the blade is incorrect.
Execute the lscfg command to correct the switch or port configuration for the ports on the blade.
EM-1047
Message
CP in slot <slot number> not faulty, CP ERROR deasserted.
Message Type LOG
Severity INFO
Probable Cause Indicates that the control processor (CP) is no longer faulted. This message usually follows the EM-1033
message. The new standby CP is in the process of restarting and has turned off the CP_ERR signal.
Recommended
Action
No action is required.
EM-1048
Message <FRU Id> I2C access recovered: state <current state>.
Message Type LOG
Severity INFO
Probable Cause Indicates that the Inter-Integrated Circuit (I2C) bus problems have been resolved and I2C access to the
field-replaceable unit (FRU) has become available again.
Recommended
Action
No action is required. The EM-1048 message is displayed when the EM-1029 error is resolved.
EM-1049
Message FRU <FRU Id> insertion detected.
Message Type LOG
Severity INFO
Probable Cause Indicates that a field-replaceable unit (FRU) of the type and location specified by the FRU ID value was
detected as having been inserted into the chassis.