Dell POWEREDGE M1000E - Manual (Page 104)

28 Fabric OS Message Reference
53-1001767-01
AG-1011
2
AG-1011
Message
<timestamp>, [AG-1011], <sequence-number>,, WARNING, <system-name>, Sending FDISC
failed on N_Port <port>.
Probable Cause Indicates there was a failure sending discover F_Port service parameter request from the Access
Gateway to the fabric switch.
Recommended
Action
Check the configuration of the fabric switch connected to the Access Gateway.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
AG-1012
Message
<timestamp>, [AG-1012], <sequence-number>,, WARNING, <system-name>, Sending
logout(LOGO)request failed on N_Port <port>.
Probable Cause Indicates there was a failure sending an N_Port logout request from the Access Gateway to the
fabric switch.
Recommended
Action
Check the configuration of the fabric switch connected to the Access Gateway.
If the message persists, run the supportFtp command (as needed) to set up automatic FTP
transfers; then run the supportSave command and contact your switch service provider.
Severity WARNING
AG-1013
Message
<timestamp>, [AG-1013], <sequence-number>,, INFO, <system-name>, F_Ports mapped
to N_Port <port> failed over to other N_Ports.
Probable Cause Indicates the specified N_Port is failing over to other N_Ports connected to the same fabric.
Recommended
Action
Run the ag --mapShow to display updated F_Port-to-N_Port mapping.
Severity INFO
AG-1014
Message
<timestamp>, [AG-1014], <sequence-number>,, INFO, <system-name>, Failing back
F_Ports mapped to N_Port <port>.
Probable Cause Indicates the specified N_Port is failing back F_Ports mapped to the specified N_Port.
Recommended
Action
Run the ag --mapShow command to display updated F_Port- to-N_Port mapping.