Dell POWEREDGE M1000E - Manual (Page 83)

Fabric OS Message Reference 7
53-1001767-01
Viewing and Configuring System Message Logs
1
2004/07/28-17:04:51, [EM-1055], 3,, WARNING, switch, Media 27: Port media
incompatible. Reason: Configured port speed.
2004/07/28-17:04:54, [FABR-1001], 4,, WARNING, switch, port 4, ELP rejected by
the other switch
2004/07/28-17:05:06, [FW-1050], 5,, WARNING, switch, Sfp Supply Voltage 0, is
below low boundary(High=3600, Low=3150). Current value is 0 mV.
switch:admin>
Viewing System Messages One Message at a Time
To display the system message log one message at a time:
1. Log in to the switch as admin.
2. At the command line, enter the errShow command:
switch:admin> errShow
Version: 5.0.1
2004/07/28-17:04:59, [FSSM-1002], 1,, INFO, switch, HA State is in sync
Type <CR> to continue, Q<CR> to stop:
2004/07/28-17:04:59, [FSSM-1003], 2,, WARNING, switch, HA State out of sync
Type <CR> to continue, Q<CR> to stop:
2004/07/28-17:04:51, [EM-1055], 3,, WARNING, switch, Media 27: Port media
incompatible
e. Reason: Configured port speed.
Type <CR> to continue, Q<CR> to stop:
Clearing the System Message Log
To clear the system message log for a particular switch instance:
1. Log in to the switch as admin.
2. Use the errClear command to clear all messages from memory.
NOTE
For products that have a single processor, all error log messages are cleared. For products that have
multiple processors, this command only clears the error logs of the processor it is executed from.
Configuring Event Auditing
To configure event auditing:
1. Configure the event classes you wish to audit:
switch:admin> auditcfg --class 1,2,3,4,5
Audit filter is configured.