Dell POWEREDGE M1000E - Manual (Page 371)

Fabric OS Message Reference 295
53-1001767-01
FW-1052
42
Recommended
Action
Frequent voltage fluctuations are an indication that the SFP is deteriorating. Replace the SFP.
Severity WARNING
FW-1052
Message
<timestamp>, [FW-1052], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the value of the small form-factor pluggable (SFP) voltage has changed from a value
outside of the acceptable range to a value within the acceptable range.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1113
Message
<timestamp>, [FW-1113], <sequence-number>,, INFO, <system-name>, <Label>, value
has changed(High=<High value>, Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the number of times E_Ports have gone down has changed. E_Ports go down each
time you remove a cable or small form-factor pluggable (SFP). SFP failures also cause E_Ports to go
down. E_Port downs might be caused by transient errors.
Recommended
Action
Check both ends of the physical connection and verify that the SFPs and cables are functioning
properly.
Severity INFO
FW-1114
Message
<timestamp>, [FW-1114], <sequence-number>,, INFO, <system-name>, <Label>, is
below low boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the number of times E_Ports have gone down has fallen below the low boundary.
E_Ports go down each time you remove a cable or small form-factor pluggable (SFP). SFP failures
also cause E_Ports to go down. E_Port downs might be caused by transient errors. A low number of
E_Port failures means that the switch is functioning normally.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO