Dell POWEREDGE M1000E - Manual (Page 153)

Fabric OS Message Reference 77
53-1001767-01
Chapter
10
BM System Messages
BM-1001
Message
<timestamp>, [BM-1001], <sequence-number>,, ERROR, <system-name>, BM protocol
version <Protocol version> in slot <Slot number>.
Probable Cause Indicates that the firmware running on the control processor (CP) cannot communicate with the
application processor (AP) blade in the indicated slot and determine the AP blade's firmware
version.
• The CP blade is running a later version of firmware than the AP blade.
• The CP blade is running an earlier version of firmware than the AP blade.
Recommended
Action
The problem can be corrected by changing the firmware version on either the control processor
(CP) or on the application processor (AP) blade. You can modify the firmware version on the CP
blade by using the firmwareDownload command. Refer to the release notes to determine whether a
non-disruptive firmware download is supported between the revisions. Because the AP and CP
blades cannot communicate, it is not possible to load new firmware on the AP blade. If needed,
send the AP blade back to the factory for a firmware update.
Severity ERROR
BM-1002
Message
<timestamp>, [BM-1002], <sequence-number>,, INFO, <system-name>, Connection
established between CP and blade in slot <Slot number> .
Probable Cause Indicates the control processor (CP) has established a connection to the blade processor (BP) and
can communicate.
Recommended
Action
No action is required as this is the expected behavior.
Severity INFO
BM-1003
Message
<timestamp>, [BM-1003], <sequence-number>,FFDC, WARNING, <system-name>, Failed to
establish connection between CP and blade in slot <Slot number>. Faulting blade.
Probable Cause Indicates the control processor (CP) could not establish a connection with the blade processor (BP)
to communicate.