Dell POWEREDGE M1000E - Manual (Page 145)

Fabric OS Message Reference 69
53-1001767-01
BL-1030
7
BL-1030
Message
<timestamp>, [BL-1030], <sequence-number>,, INFO, <system-name>, All GigE/FCIP
Virtualization/FC Fastwrite ports on the switch will be reset as part of the
firmware upgrade.
Probable Cause Indicates that a recent firmware upgrade caused the switch's internal processor firmware to be
upgraded and resulted in the cold upgrade. As part of the upgrade, all the GbE or Fibre Channel
over IP (FCIP) or Virtualization data elements or FC Fastwrite ports were reset.
Recommended
Action
No action is required.
Severity INFO
BL-1031
Message
<timestamp>, [BL-1031], <sequence-number>,, CRITICAL, <system-name>, Link timeout
in internal port (slot <Slot number>, port <Port number>) resulted in blade fault.
Use slotpoweroff/slotpoweron to recover the blade.
Probable Cause Indicates that link timeout occurred in one of the backend internal ports.
Recommended
Action
Power cycle the blade or run the slotPowerOff and slotPowerOn commands.
Severity CRITICAL
BL-1032
Message
<timestamp>, [BL-1032], <sequence-number>,, CRITICAL, <system-name>, (slot <slot
number>,bitmap 0x<object control flags(bitmap)>) ports never came up ONLINE
(reason <reason for port disable>, state <status of the blade>). Disabling slot.
Probable Cause Indicates that back-end (non-user) ports have not come ONLINE within time limit.
Recommended
Action
Restart or power cycle the blade. Run the systemVerification command to verify that the blade does
not have hardware problems. Run the diagPost command to ensure that Power-On Self-Test (POST)
is enabled. If the message persists, replace the blade.
Refer to the Fabric OS Command Reference for more information on the systemVerification
command.
Severity CRITICAL
BL-1033
Message
<timestamp>, [BL-1033], <sequence-number>,, CRITICAL, <system-name>, (slot <slot
number>,bitmap 0x<object control flags(bitmap)>) No disable acknowledgment from
ports (state <status of the blade>). Disabling slot.