Dell POWEREDGE M1000E - Manual (Page 609)

Fabric OS Message Reference 533
53-1001767-01
SEC-1138
90
SEC-1138
Message
<timestamp>, [SEC-1138], <sequence-number>,, INFO, <system-name>, Security
database download received from Primary FCS.
Probable Cause Indicates that a non-primary fabric configuration server (FCS) switch received a security database
download.
Recommended
Action
Verify that the security event was planned. If the security event was planned, no action is required.
If the security event was not planned, take appropriate action as defined by your enterprise security
policy.
Severity INFO
SEC-1139
Message
<timestamp>, [SEC-1139], <sequence-number>,, ERROR, <system-name>, The
RSNMP_POLICY cannot exist without the WSNMP_POLICY.
Probable Cause Indicates that the receiving switch failed to validate the security database sent from the primary
fabric configuration server (FCS) switch. This message usually indicates that the data package is
corrupted, the time stamp on the package is out of range as a result of a replay attack or
out-of-sync time service, or the signature verification failed. Signature verification failure indicates
either an internal error (such as losing the primary public key) or an invalid database.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that switch. This message might also be the result of an internal corruption or a hacker attack to
the secure fabric.
Severity ERROR
SEC-1142
Message
<timestamp>, [SEC-1142], <sequence-number>,, INFO, <system-name>, Reject new
policies. <reason text>.
Probable Cause Indicates the new polices are rejected due to the reason specified.
Recommended
Action
Use proper syntax when entering policy information.
Severity INFO
SEC-1145
Message
<timestamp>, [SEC-1145], <sequence-number>,, INFO, <system-name>, A security
admin event has occurred. This message is for information purpose only. The
message for individual event is: <Event specific data>