Dell POWEREDGE M1000E - Manual (Page 595)

Fabric OS Message Reference 519
53-1001767-01
SEC-1078
90
Severity ERROR
SEC-1078
Message
<timestamp>, [SEC-1078], <sequence-number>,, ERROR, <system-name>, No new data to
abort.
Probable Cause Indicates there are no new changes in the defined security policy database that can be aborted.
Recommended
Action
Verify the security event was planned. Verify if there were really any changes to the defined policy
database that can be aborted.
Severity ERROR
SEC-1079
Message
<timestamp>, [SEC-1079], <sequence-number>,, ERROR, <system-name>, The policy
name <policy name> is invalid.
Probable Cause Indicates the policy name entered in the secPolicyCreate|Activate|Add|Delete command was
invalid.
Recommended
Action
Run the command again using a valid policy name.
Severity ERROR
SEC-1080
Message
<timestamp>, [SEC-1080], <sequence-number>,, ERROR, <system-name>, Operation
denied. Please, use secModeEnable command.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1081
Message
<timestamp>, [SEC-1081], <sequence-number>,, ERROR, <system-name>, Entered a name
for a DCC policy ID that was not unique.