Dell POWEREDGE M1000E - Manual (Page 398)

322 Fabric OS Message Reference
53-1001767-01
FW-1274
42
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1274
Message
<timestamp>, [FW-1274], <sequence-number>,, INFO, <system-name>, <Label>, is
above high boundary(High=<Filter Counter>, Low=<Low value>). Current value is
<Value> <Unit>.
Probable Cause Indicates that the number of frame types or commands that the port receives has risen above the
high boundary. The port has received a small computer system interface (SCSI) Read, SCSI Write,
SCSI Read and Write, SCSI Traffic, or IP commands in a frame.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1275
Message
<timestamp>, [FW-1275], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the number of frame types or commands that the port receives has changed from a
value outside of the acceptable range to a value within the acceptable range. The port has received
a small computer system interface (SCSI) Read, SCSI Write, SCSI Read and Write, SCSI Traffic, or IP
commands in a frame.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1296
Message
<timestamp>, [FW-1296], <sequence-number>,, INFO, <system-name>, <Label>, value
has changed(High=<High value>, Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the number of Telnet violations has changed. Telnet violations indicate that a Telnet
connection request has been received from an unauthorized IP address. The TELNET_POLICY
contains a list of internet protocol (IP) addresses that are authorized to establish Telnet
connections to switches in the fabric.
Recommended
Action
Run the errShow command to determine the IP address that sent the request. Responses to
security-class messages depend on user policies. Consult your security administrator for response
strategies and policies.