Dell POWEREDGE M1000E - Manual (Page 584)

508 Fabric OS Message Reference
53-1001767-01
SEC-1029
90
SEC-1029
Message
<timestamp>, [SEC-1029], <sequence-number>,, ERROR, <system-name>, Invalid
character in <policy name>.
Probable Cause Indicates a corruption occurred during the distribution of the security database. This can occur only
when the primary fabric configuration server (FCS) distributes the security database to the other
switches in the fabric, then local validation finds the error in the security database. This is a rare
occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1030
Message
<timestamp>, [SEC-1030], <sequence-number>, ERROR, <system-name>, The length of
the name invalid.
Probable Cause Indicates a corruption occurred during the distribution of the security database. This can occur only
when the primary fabric configuration server (FCS) distributes the security database to the other
switches in the fabric, then local validation finds the error in the security database. This is a rare
occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1031
Message
<timestamp>, [SEC-1031], <sequence-number>,, WARNING, <system-name>, Current
security policy DB cannot be supported by standby. CPs will go out of sync.
Probable Cause Indicates the security database size is not supported by the standby control processor (CP).
Recommended
Action
Reduce the security policy size by deleting entries within a policy or by deleting some policies.
Severity WARNING
SEC-1032
Message
<timestamp>, [SEC-1032], <sequence-number>,, ERROR, <system-name>, Empty FCS list
is not allowed.