Dell POWEREDGE M1000E - Manual (Page 148)

72 Fabric OS Message Reference
53-1001767-01
BL-1045
7
BL-1045
Message
<timestamp>, [BL-1045], <sequence-number>,, ERROR, <system-name>, mini SFP+ (SN:
<mini SFP+ serial number>) is only supported in certain high port count blades,
not blade in slot <slot number of blade that has the mini SFP+> w/ ID <Blade ID of
blade that has the mini SFP+ that does not support it>.
Probable Cause Indicates that the mini (form factor) SFP+ is supported only by a certain type of blade (FC8-64),
but it can be inserted in other blades.
Recommended
Action
Replace the mini SFP+ with an SFP or SFP+.
Severity ERROR
BL-1046
Message
<timestamp>, [BL-1046], <sequence-number>,, ERROR, <system-name>, <Slot number of
blade that has the SFP> error on SFP in Slot <Port number into which the SFP is
inserted>/Port <The type of error "checksum" or "data access" for general problems
accessing the i2c accessible data> (<A detailed error code>). Try reseating or
replacing it.
Probable Cause Indicates the checksum in an area on the SFP does not match with the computed one or there is
problem accessing the data.
Recommended
Action
Try reseating the SFP, if problem persists replace it.
Severity ERROR