Dell POWEREDGE M1000E - Manual (Page 610)

534 Fabric OS Message Reference
53-1001767-01
SEC-1146
90
Probable Cause Indicates one of the following has occurred:
• The names for the specified policies have changed.
• The passwords have changed for the specified accounts.
• The SNMP community strings have been changed.
Recommended
Action
Verify the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security
policy.
Severity INFO
SEC-1146
Message
<timestamp>, [SEC-1146], <sequence-number>,, INFO, <system-name>, PID changed:
<State>.
Probable Cause Indicates the PID format of the switch was changed either to extended-edge PID or from
extended-edge PID. If the device connection control (DCC) polices existed, all index/area ID values
either increased or decreased by 16. The values wrap around after 128. If a DCC policy contains an
index/area of 127 before changing to extended-edge PID, then the new index/area is 15, because
of the wraparound.
Recommended
Action
No action is required.
Severity INFO
SEC-1153
Message
<timestamp>, [SEC-1153], <sequence-number>,, INFO, <system-name>, Error in RCA:
RCS is not supported
Probable Cause Indicates that reliable commit service (RCS) is not supported.
Recommended
Action
Run the rcsInfoShow command to view RCS capability on the fabric. RCS must be capable on all
switches in the fabric to be enabled. If all switches are capable, it is automatically enabled.
For any switch that does not support RCS, obtain the latest firmware version from your switch
supplier, and run the firmwareDownload command to upgrade the firmware.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity INFO
SEC-1154
Message
<timestamp>, [SEC-1154], <sequence-number>,, INFO, <system-name>, PID change
failed: <Reason> <defined status> <active status>.