Dell POWEREDGE M1000E - Manual (Page 612)

536 Fabric OS Message Reference
53-1001767-01
SEC-1158
90
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity INFO
SEC-1158
Message
<timestamp>, [SEC-1158], <sequence-number>,, INFO, <system-name>, Invalid name
<Policy or Switch name>.
Probable Cause Indicates the specified name is invalid. The name can be a policy name or a switch name.
Recommended
Action
Enter a valid name.
Severity INFO
SEC-1159
Message
<timestamp>, [SEC-1159], <sequence-number>,, INFO, <system-name>, Non_Reachable
domain <Domain ID>.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity INFO
SEC-1160
Message
<timestamp>, [SEC-1160], <sequence-number>,, INFO, <system-name>, Duplicate port
<port ID> in port list (<port list>).
Probable Cause Indicates a duplicate port member exists in the specified port list.
Recommended
Action
Verify that there is no duplicate member in the port list.
Severity INFO
SEC-1163
Message
<timestamp>, [SEC-1163], <sequence-number>,, ERROR, <system-name>, System is
already in secure mode. Lockdown option cannot be applied.