Dell POWEREDGE M1000E - Manual (Page 623)

Fabric OS Message Reference 547
53-1001767-01
SEC-1202
90
Severity INFO
SEC-1202
Message
<timestamp>, [SEC-1202], <sequence-number>,, INFO, <system-name>, Security
violation: Unauthorized access from MS device node name <device node name>, device
port name <device port name>.
Probable Cause Indicates a management server (MS) security violation was reported. The unauthorized device
specified in the message attempted to establish a connection.
Recommended
Action
Check the MS server policy and verify that the connection is allowed. If the connection is allowed
but not specified, enable the connection in the MS policy. If the MS policy does not allow the
connection, this is a valid violation message and an unauthorized entity is trying to access your
fabric. Take appropriate action, as defined by your enterprise security policy.
Severity INFO
SEC-1203
Message
<timestamp>, [SEC-1203], <sequence-number>,, INFO, <system-name>, Login
information: Login successful via TELNET/SSH/RSH. IP Addr: <IP address>
Probable Cause Indicates the IP address of the remote station logging in.
Recommended
Action
No action is required.
Severity INFO
SEC-1250
Message
<timestamp>, [SEC-1250], <sequence-number>,, WARNING, <system-name>, DCC
enforcement API failed: <failed action> err=<status>, key=<data>
Probable Cause Indicates an internal error caused the DCC policy enforcement to fail.
Recommended
Action
Retry the failed security command.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
SEC-1251
Message
<timestamp>, [SEC-1251], <sequence-number>,, ERROR, <system-name>, Policy to
binary conversion error: <text message> <value>.