Dell POWEREDGE M1000E - Manual (Page 590)

514 Fabric OS Message Reference
53-1001767-01
SEC-1053
90
Severity ERROR
SEC-1053
Message
<timestamp>, [SEC-1053], <sequence-number>,, ERROR, <system-name>, Invalid pFCS
list <pFCS list>
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1054
Message
<timestamp>, [SEC-1054], <sequence-number>,, ERROR, <system-name>, Invalid FCS
list length <list length>
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1055
Message
<timestamp>, [SEC-1055], <sequence-number>,, ERROR, <system-name>, Invalid FCS
list <WWN list>
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR