Dell POWEREDGE M1000E User Manual
Page 817
Fabric OS Message Reference
741
53-1001767-01
SULB-1009
128
“firmwareCommit operation failed due to IPC error.”
0x55
"Unable to check the firmware version on Standby CP due to IPC error."
0x56
“Unable to restore the original firmware due to Standby CP timeout.”
0x57
"Standby CP failed to reboot and was not responding."
0x58
"Unable to check the firmware version on Standby CP due to IPC error."
0x59
“Sanity check failed because firmwareDownload is already in progress.”
0x60
“Sanity check failed because firmwareDownload is already in progress.”
0x61
NOT USED
0x62
"System Error."
0x63
"Active CP forced failover succeeded. Now this CP becomes Active."
0x64
"Standby CP booted up."
0x65
"Active and Standby CP failed to gain HA synchronization within 10 minutes."
0x66
"Standby rebooted successfully."
0x67
"Standby failed to reboot."
0x68
“firmwareCommit has started to restore the secondary partition.”
0x69
"Local CP is restoring its secondary partition."
0x6a
“Unable to restore the secondary partition. Please use firmwareDownloadStatus and
firmwareShow to see firmware status.”
0x6b
“firmwareDownload has started on Standby CP. It might take up to 10 minutes.”
0x6c
“firmwareDownload has completed successfully on Standby CP.”
0x6d
"Standby CP reboots."
0x6e
"Standby CP failed to boot up."
0x6f
"Standby CP booted up with new firmware."
0x70
"Standby CP failed to boot up with new firmware."
0x71
“firmwareDownload has completed successfully on Standby CP.”
0x72
“firmwareDownload has started on Standby CP. It might take up to 10 minutes.”
0x73
“firmwareDownload has completed successfully on Standby CP.”
0x74
"Standby CP reboots."
0x75
"Standby CP failed to reboot."
0x76
“firmwareCommit has started on Standby CP.”
0x77
“firmwareCommit has completed successfully on Standby CP.”
0x78
"Standby CP booted up with new firmware."
0x79
"Standby CP failed to boot up with new firmware."
0x7a
“firmwareCommit has started on both Active and Standby CPs.”
0x7b
“firmwareCommit has completed successfully on both CPs.”
0x7c
“firmwareCommit failed on Active CP.”
0x7d
TABLE 9
Status Messages and Status Codes
Status Message
Status Code