Dell POWEREDGE M1000E - Manual (Page 328)

252 Fabric OS Message Reference
53-1001767-01
FICN-1045
35
FICN-1045
Message
<timestamp>, [FICN-1045], <sequence-number>,, WARNING, <system-name>,
HostTapeIng:FICON Purge received:Path=<VEPortNumber HostDomain HostPort
DeviceDomain> <DevicePort LPAR CUADDR DeviceAddr>.
Probable Cause Indicates a purge path was received from the locally connected FICON channel. This is performed
during the path recovery.
Recommended
Action
If this was an unexpected event, contact your vendor's customer support for assistance.
Severity WARNING
FICN-1046
Message
<timestamp>, [FICN-1046], <sequence-number>,, WARNING, <system-name>,
HostTapeIng:LRJ received on Path=<VEPortNumber HostDomain HostPort DeviceDomain>
<DevicePort LPAR CUADDR DeviceAddr>lastCmds=0x<Last 4 commands received from the
channel for this device> lastStatus=0x<Last 4 status values presented to the
channel for this device> treating as system reset event.
Probable Cause Indicates an LRJ from a FICON channel indicates that the channel believes that it no longer has a
path established to the CU.
Recommended
Action
This is normally an unexpected event, please contact your vendor's customer support for
assistance.
Severity WARNING
FICN-1047
Message
<timestamp>, [FICN-1047], <sequence-number>,, ERROR, <system-name>,
fcFicSetEmulation:Path=<VEPortNumber HostDomain HostPort DeviceDomain>
<DevicePort LPAR CUADDR DeviceAddr>FDCB Not Idle state=0x<Current emulation state
of the FICON device> prevState=0x<Previous emulation state of the FICON device>
set to state=0x<The new state to which the device is transitioning>.
Probable Cause Indicates there is an internal emulation error. This message should not be encountered.
Recommended
Action
This is an unexpected event, please contact your vendor's customer support for assistance.
Severity ERROR
FICN-1048
Message
<timestamp>, [FICN-1048], <sequence-number>,, WARNING, <system-name>,
DevDiskEgr:FICON Cancel received Path=<VEPortNumber HostDomain HostPort
DeviceDomain> <DevicePort LPAR CUADDR DeviceAddr> state=0x<Current emulation
state of the FICON device> sflags=0x<The current emulation status flags>.