Sec-1320, Sec-1321, Sec-1322 – Dell POWEREDGE M1000E User Manual
Page 630: Sec-1323
554
Fabric OS Message Reference
53-1001767-01
SEC-1320
90
SEC-1320
Message
<timestamp>, [SEC-1320], <sequence-number>,, WARNING, <system-name>, Non-acl
domain <Domain Number> tries to join a fabric with strict fabric wide policy
Probable Cause
Indicates that a domain not supporting an access control list (ACL) policy tried to join a fabric with a
strict fabric-wide policy.
Recommended
Action
No action is required. The domain is denied by disallowing all its E_ports from connecting to the
fabric.
Severity
WARNING
SEC-1321
Message
<timestamp>, [SEC-1321], <sequence-number>,, ERROR, <system-name>, Failed secure
mode enable command. Reason: <Reason>.
Probable Cause
Indicates the security enable failed on the fabric because the switch has a conflicting configuration
such as fabric wide consistency configuration or AD configuration.
Recommended
Action
Verify the security event was planned.
If the security event was planned, run the fddcfg --fabwideset “” command or ad --clear
command to clear the fabric wide consistency configuration or AD configuration and retry the
secModeEnable command.
Severity
ERROR
SEC-1322
Message
<timestamp>, [SEC-1322], <sequence-number>,, WARNING, <system-name>, Some DCC
policy is too large, distribution cancelled
Probable Cause
Indicates this fabric is not able to support a device connection control (DCC) policy with more than
256 ports.
Recommended
Action
Reconfigure any policy that includes more than 256 ports in its member list, then save the policy
configuration changes.
Severity
WARNING
SEC-1323
Message
<timestamp>, [SEC-1323], <sequence-number>,, INFO, <system-name>, Keys \"<Key
Name>\" ignored during configdownload.
Probable Cause
Indicates the specified key is ignored during configDownload.