Dell POWEREDGE M1000E - Manual (Page 163)

Fabric OS Message Reference 87
53-1001767-01
Chapter
12
CDR System Messages
CDR-1001
Message
<timestamp>, [CDR-1001], <sequence-number>,, ERROR, <system-name>, Port <port
number> port fault. Please change the SFP or check cable
Probable Cause Indicates a deteriorated small form-factor pluggable (SFP), an incompatible SFP pair, a faulty cable
between peer ports, or that the port speed configuration does not match the capability of the SFP.
Recommended
Action
Ensure that you are using compatible SFPs on the peer ports.
Verify whether the SFPs have deteriorated or the Fibre Channel cable is faulty. Replace the SFPs or
cable, if necessary.
Severity ERROR
CDR-1002
Message
<timestamp>, [CDR-1002], <sequence-number>, FFDC, ERROR, <system-name>, Port
<port number> chip faulted due to internal error.
Probable Cause Indicates an internal error.
Recommended
Action
For a bladed system, execute the slotPowerOff and slotPowerOn commands on the blade to recover
the system. For a non-bladed system, perform fastBoot command on the switch to recover the
system.
Severity ERROR
CDR-1003
Message
<timestamp>, [CDR-1003], <sequence-number>, FFDC, CRITICAL, <system-name>, <slot
number>, <chip index> HW ASIC chip error type =0<chip error type>
Probable Cause Indicates an internal error in the application specific integrated circuit (ASIC) hardware that may
degrade data traffic.
Recommended
Action
Whenever this error occurs, restart the system at the next maintenance window. If the problem
persists, replace the blade.