Dell POWEREDGE M1000E - Manual (Page 603)

Fabric OS Message Reference 527
53-1001767-01
SEC-1107
90
SEC-1107
Message
<timestamp>, [SEC-1107], <sequence-number>,, INFO, <system-name>, Stamp is 0.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity INFO
SEC-1108
Message
<timestamp>, [SEC-1108], <sequence-number>,, ERROR, <system-name>, Fail to reset
stamp on all switches.
Probable Cause Indicates that a version reset operation failed either because the switch could not get all the
required resources to perform the operation or because it failed to send the message to all
switches in the fabric.
Recommended
Action
Verify that the security event was planned. If the security event was planned, run the
secFabricShow command to verify that all switches in the fabric are in the ready state. When all
switches are in the ready state, retry the operation.
Severity ERROR
SEC-1110
Message
<timestamp>, [SEC-1110], <sequence-number>,, ERROR, <system-name>, FCS list must
be the first entry in the [Defined Security policies] section. Fail to download
defined database.
Probable Cause Indicates that a security policy download is attempted with a defined policy that does not have the
fabric configuration server (FCS) policy as the first policy. The FCS policy is required to be the first
policy in the defined security database.
Recommended
Action
Download a correct configuration with the fabric configuration server (FCS) policy as the first policy
in the defined security database.
Severity ERROR
SEC-1111
Message
<timestamp>, [SEC-1111], <sequence-number>,, ERROR, <system-name>, New defined
FCS list must have at least one member in common with current active FCS list.
Fail to download defined database.