Dell POWEREDGE M1000E - Manual (Page 230)

154 Fabric OS Message Reference
53-1001767-01
EM-1016
22
Severity WARNING
EM-1016
Message
<timestamp>, [EM-1016], <sequence-number>,, WARNING, <system-name>, Cold recovery
failed ( <Return code> ).
Probable Cause Indicates that a problem was discovered when performing consistency checks during a cold boot.
Recommended
Action
Monitor the switch.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
EM-1017
Message
<timestamp>, [EM-1017], <sequence-number>,, WARNING, <system-name>, Uncommitted
WWN change detected. Cold reboot required.
Probable Cause Indicates that a user did not commit a changed world wide name (WWN) value prior to executing a
reboot, power cycle, or firmwareDownload operation.
Recommended
Action
Change and commit the new WWN value.
Severity WARNING
EM-1018
Message
<timestamp>, [EM-1018], <sequence-number>, FFDC, CRITICAL, <system-name>, CP
blade in slot <slot number> failed to retrieve current chassis type (<detailed
fault descriptor>/<PLACE HOLDER>/0x<PLACE HOLDER>).
Probable Cause Indicates that there was a failure to read the chassis type from the system.
Recommended
Action
Verify that the control processor (CP) blade is operational and is properly seated in its slot.
Severity CRITICAL
EM-1019
Message
<timestamp>, [EM-1019], <sequence-number>,, WARNING, <system-name>, Current
chassis configuration option ( <Chassis config option currently in effect> )
is not compatible with standby firmware version (Pre 4.4), cannot allow HA Sync.