Dell POWEREDGE M1000E - Manual (Page 87)

Fabric OS Message Reference 11
53-1001767-01
Responding to a System Message
1
Message Severity Levels
There are four levels of severity for messages, ranging from Critical (1) to Info (4). In general, the
definitions are wide ranging and are to be used as general guidelines for troubleshooting. For all
cases, you should look at each specific error message description thoroughly before taking action.
System messages have the following severity levels.
Responding to a System Message
This section provides procedures on gathering information on system messages, including:
• Looking Up a System Message
• Gathering Information About the Problem
• Support
• Panic Dump and Core Dump Files
• Trace Dumps
• supportSave Command
switchname Switch name or chassis
name, depending on
the action; for example,
HA messages typically
show the chassis name
and login failures show
the logical switch
name. The defined switch name or the chassis name of the
switch. This value is truncated if it is over 16
characters in length. Run either the chassisName
command to name the chassis or the switchName
command to rename the logical switch.
, ,
Null Reserved for future use.
Slot 7 ejector not
closed
Error Description A text string explaining the error encountered and
providing parameters supplied by the software at
runtime.
1 = CRITICAL Critical-level messages indicate that the software has detected serious problems that will
cause a partial or complete failure of a subsystem if not corrected immediately; for example, a
power supply failure or rise in temperature must receive immediate attention.
2 = ERROR Error-level messages represent an error condition that does not impact overall system
functionality significantly. For example, error-level messages might indicate time-outs on
certain operations, failures of certain operations after retries, invalid parameters, or failure to
perform a requested operation.
3 = WARNING Warning-level messages highlight a current operating condition that should be checked or it
might lead to a failure in the future. For example, a power supply failure in a redundant system
relays a warning that the system is no longer operating in redundant mode unless the failed
power supply is replaced or fixed.
4 = INFO Info-level messages report the current non-error status of the system components: for
example, detecting online and offline status of a fabric port.
TABLE 4 Audit Message Field Description (Continued)
Example Variable Name Description