Dell POWEREDGE M1000E - Manual (Page 685)

Fabric OS Message Reference 609
53-1001767-01
SULB-1008
97
SULB-1008
Message
<timestamp>, [SULB-1008], <sequence-number>,, INFO, <system-name>, Standby CP
booted successfully with new firmware.
Probable Cause Indicates the standby CP has rebooted successfully.
Recommended
Action
No action is required. The firmwareDownload command is progressing as expected.
Run the firmwareDownloadStatus command for more information.
Severity INFO
SULB-1009
Message
AUDIT, <timestamp>, [SULB-1009], AUDIT, INFO, FIRMWARE,
<event-initiator-details>, <event-location>, , Firmwaredownload command failed.
status: 0x<status code>, error: 0x<error code>.
Probable Cause Indicates the firmwareDownload command failed. The additional status code and error code
provide debugging information.
Table lists firmwareDownload status messages and status codes. Some of them will not show up
in this RASLOG message.
TABLE 6 Status Messages and Status Codes
Status Message Status Code
“firmwareDownload sanity check failed.” 0x30
"Sanity check failed because system is non-redundant." 0x31
“Sanity check failed because firmwareDownload is already in progress.” 0x32
"Sanity check failed because FABRIC OS is disabled on Active CP." 0x33
"Sanity check failed because HAMD is disabled on Active CP." 0x34
“Sanity check failed because firmwareDownload is already in progress.” 0x35
"Sanity check failed because FABRIC OS is disabled on Standby CP." 0x36
"Sanity check failed because HAMD is disabled on Standby CP." 0x37
“firmwareDownload failed on Standby CP.” 0x40
“firmwareDownload failed on Standby CP.” 0x41
“firmwareDownload failed on Standby CP.” 0x42
“firmwareCommit failed on Standby CP.” 0x43
“firmwareDownload failed.” 0x44
“firmwareDownload failed due to IPC error.” 0x50
"Unable to check the firmware version on Standby CP due to IPC error." 0x51
“firmwareDownload failed due to IPC error.” 0x52
“firmwareDownload failed due to IPC error.” 0x53
"Standby CP failed to reboot due to IPC error." 0x54