Dell POWEREDGE M1000E - Manual (Page 558)

482 Fabric OS Message Reference
53-1001767-01
PSWP-1004
81
PSWP-1004
Message
<timestamp>, [PSWP-1004], <sequence-number>,, INFO, <system-name>, Blade Swap
complete for slots <slot number corresponding to the source blade> and <slot
number corresponding to the destination blade>.
Probable Cause Indicates that the bladeSwap command has been issued.
Recommended
Action
No action is required.
Severity INFO
PSWP-1005
Message
<timestamp>, [PSWP-1005, <sequence-number>,, WARNING, <system-name>, Blade Swap
undo failed with error code <error code from undoBladeSwap>.
Probable Cause Indicates that the bladeSwap undo command has failed.
Recommended
Action
Use the portSwapShow command to display a list of currently swapped ports. Then use the
portSwap command to acheive the desired result.
Severity WARNING
PSWP-1006
Message
<timestamp>, [PSWP-1006, <sequence-number>,, WARNING, <system-name>, Blade Swap
failed on configInit with error code <error code from configInit.>in switch number
<current switch number>.
Probable Cause Indicates that the bladeSwap command has failed to access the configuration data.
Recommended
Action
Retry the command. If the failure persists, contact your support representative.
Severity WARNING
PSWP-1007
Message
<timestamp>, [PSWP-1007, <sequence-number>,, WARNING, <system-name>, Blade Swap
failed on fabosInit with error code <error code from fabosInit.>in switch number
<current switch number>.
Probable Cause Indicates that the bladeSwap command has failed to access the switch context.
Recommended
Action
Retry the command. If the failure persists, contact your support representative.
Severity WARNING