PLANET WGSW-52040 - Manual (Page 129)

3-128
provided, it means to reboot all member switches.
Default:
Boot all member switches.
Command mode:
Admin Mode.
Instructions:
In the commander switch, users can use this command to reset a member switch. If this command is executed in a
non-commander switch, an error will be displayed.
Example:
In the commander switch, reset the member switch 1.
Switch#cluster reset member 1
3.10 cluster run
Command:
cluster run [key <WORD>] [vid <VID>]
no cluster run
Function:
Enable cluster function; the “no cluster run” command disables cluster function.
Parameter:
key：all keys in one cluster should be the same, no longer than 16 characters.
vid：vlan id of the cluster, whose range is 1-4094.
Command mode:
Global Mode
Default:
Cluster function is disabled by default, key: NULL(\0) vid：1.
Instructions:
This command enables cluster function. Cluster function has to be enabled before implementing any other cluster
commands. The “no cluster run” disables cluster function. It is recommended that users allocate an exclusive vlan
for cluster（such as vlan100）