PLANET WGSW-52040 - Manual (Page 874)

65-414
Function:
Set the max rate of the CPU receiving packets of the protocol type, the no command set the max rate to default.
Parameter:
<protocol-type> is the type of the protocol, including dot1x, stp, snmp, arp, telnet, http, dhcp, igmp, ssh; <packets>
is the max rate of CPU receiving packets of the protocol type, its range is 1-2000 pps.
Command Mode:
Global Mode
Default:
A different default rate is set for the different type of protocol.
Usage Guide:
The rate limit set by this command have an effect on CPU receiving packets, so it is supposed to be used with the
help of the technical support.
Example:
Set the rate of the ARP packets to 500pps.
Switch(config)#cpu-rx-ratelimit protocol arp 500
65.3 cpu-rx-ratelimit total
Command:
cpu-rx-ratelimit total <packets>
no cpu-rx-ratelimit total
Function:
Set the total rate of the CPU receiving packets, the no command sets the total rate of the CPU receiving packets to
default.
Parameter:
<packets> is the max number of CPU receiving packets per second.
Command Mode:
Global Mode