PLANET WGSW-52040 - Manual (Page 242)

14-11
Example:
Enable LLDP-MED TRAP of the port 19.
Switch(Config-If-Ethernet1/19)# lldp med trap enable
14.6 lldp transmit med tlv all
Command:
lldp transmit med tlv all
no lldp transmit med tlv all
Function:
Configure the specified port to send all LLDP-MED TLVs, the no command disables the function.
Parameter:
None.
Default:
Port does not enable the function for Sending LLDP-MED TLV.
Command Mode:
Port mode
Usage Guide:
After configuring this command, if the port is able to send LLDP-MED TLV, the sent LLDP packets with LLDP-MED
TLV supported by all switches. However, LLDP packets sent by the port without any LLDP-MED TLV after the switch
configured the corresponding no command.
Example:
Port 19 enables the function for sending LLDP-MED TLV.
Switch(Config-If-Ethernet1/19)# lldp transmit med tlv all
14.7 lldp transmit med tlv capability
Command:
lldp transmit med tlv capability
no lldp transmit med tlv capability