PLANET WGSW-52040 - Manual (Page 808)

56-348
switch (config)#sflow priority 1
56.8 sflow rate
Command:
sflow rate { input <input-rate> | output <output-rate >}
no sflow rate [input | output]
Function:
Configure the sample rate of the sFlow hardware sampling. The “no” form of this command deletes the sampling rate
value.
Parameter:
<input-rate> is the rate of ingress group sampling, the valid range is 1000~16383500.
<output-rate> is the rate of egress group sampling, the valid range is 1000~16383500.
Command Mode:
Port Mode.
Default:
No default value.
Usage Guide:
The traffic sampling will not be performed if the sampling rate is not configured on the port. And if the ingress group
sampling rate is set to 10000, this indicates there will be one group be sampled every 10000 ingress groups.
Example:
Configure the ingress sample rate on port e1/1 to 10000 and the egress sample rate to 20000.
Switch(Config-If-Ethernet1/1)#sflow rate input 10000
Switch(Config-If-Ethernet1/1)#sflow rate output 20000
56.9 show sflow
Command:
show sflow