PLANET WGSW-52040 - Manual (Page 185)

8-184
Function:
enable: configure to enable the Trap function on the specified port; disable: configure to disable the Trap function
on the specified port.
Parameters:
None.
Default:
The Trap function is disabled on the specified port by default.
Command Mode:
Port Configuration Mode.
Usage Guide:
The function of sending Trap messages is enabled on the port.
Example:
Enable the Trap function on port ethernet 1/5 of the switch.
Switch(config)#in ethernet1/5
Switch(Config-If-Ethernet1/5)#lldp trap enable
8.14 lldp tx-interval
Command:
lldp tx-interval <integer>
no lldp tx-interval
Function:
Set the interval of sending update messages on all the ports with LLDP function enabled, the value of which ranges
from 5 to 32768 seconds and is 30 seconds by default.
Parameters:
<integer> is the interval of sending updating messages, ranging from 5 to 32768 seconds.
Default:
30 seconds.