PLANET WGSW-52040 - Manual (Page 453)

28-64
<code> is the code for network parameters; <string> is the ASCII string up to 255 characters; <hex> is a value in
Hex that is no greater than 510 and must be of even length; <ipaddress> is the IP address in decimal format, up to
63 IP addresses can be configured.
Command Mode:
DHCP Address Pool Mode
Default:
None
Usage Guide:
The switch provides common commands for network parameter configuration as well as various commands useful in
network configuration to meet different user needs. The definition of option code is described in detail in RFC2123.
Example:
Setting the WWW server address as 10.1.128.240.
Switch(dhcp-1-config)#option 72 ip 10.1.128.240
28.1.28 service dhcp
Command:
service dhcp
no service dhcp
Function:
Enables DHCP server; the “no service dhcp” command disables the DHCP service.
Parameters:
None
Default:
DHCP service is disabled by default.
Command mode:
Global Mode
Usage Guide:
Both DHCP server and DHCP relay are included in the DHCP service. When DHCP services are enabled, both
DHCP server and DHCP relay are enabled. Switch can only assign IP address for the DHCP clients and enable