PLANET WGSW-52040 - Manual (Page 640)

39-180
auto enable 802.1x authentication, the port authorization status is determined by the authentication information
between the switch and the supplicant; force-authorized sets port to authorized status, unauthenticated data is
allowed to pass through the port; force-unauthorized will set the port to non-authorized mode, the switch will not
provide authentication for the supplicant and prohibit data from passing through the port.
Command mode:
Port configuration Mode
Default:
When 802.1x is enabled for the port, auto is set by default.
Usage Guide:
If the port needs to provide 802.1x authentication for the user, the port authentication mode should be set to auto.
Example:
Setting port1/1 to require 802.1x authentication mode.
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#dot1x port-control auto
39.19 dot1x port-method
Command:
dot1x port-method {macbased | portbased | userbased {standard | advanced}}
no dot1x port-method
Function:
To configure the access control method of appointed interface. The no form command restores the default access
control method.
Parameter:
macbased means the access control method based on MAC address
portbased means the access control method based on port
userbased means the access control method based on user, it can be divided into two types, one is standard access
control method, and the other is advanced access control method
Command mode:
Port Configuration Mode.