PLANET WGSW-52040 - Manual (Page 429)

25-40
Usage Guide:
This command will convert the dynamic ARP entries to static ones, which, in combination with disabling automatic
learning, can prevent ARP binding. Once implemented, this command will lose its effect.
Example:
Switch(Config-if-Vlan1)#ip arp -security convert
Switch(config)#ip arp -security convert
25.4 clear ip arp dynamic
Command:
clear ip arp dynamic
Function:
Clear all of dynamic ARP on interface.
Parameter:
None
Command Mode:
Interface Configuration
Usage Guide:
This command will clear dynamic entries before binding ARP. Once implemented, this command will lose its effect.
Example:
Switch(Config-if-Vlan1)#clear ip arp dynamic
25.5 clear ipv6 nd dynamic
Command:
clear ipv6 nd dynamic
Function: