PLANET WGSW-52040 - Manual (Page 815)

58-355
58.2 monitor session destination tunnel
Command:
monitor session <session> destination tunnel <tunnel-number>
no monitor session <session> destination tunnel <tunnel-number>
Function:
Specify the destination port of the mirror as the tunnel. The no command deletes this configuration.
Parameters:
<session> is the session number of the mirror, which is currently limited from 1 to 4; <tunnel-number> is the tunnel
number.
Default:
No configuration
Command Mode:
Global mode
Usage Guide:
4 destination tunnels are supported on the switch. To be mentioned, the destination tunnel which is configured as the
physical ports or tunnel, it should not be configured as the member of the port aggregation group. And the maximum
throughput of the port is recommended to be larger than the total throughput of the source ports to be mirrored. If the
destination tunnel of a session is removed, the mirror path configured in the session will be removed at the same
time. And if the destination tunnel is reconfigured, the port mirror path will be recovered. To be mentioned, the flow
mirror can only be recovered after the destination port is reconfigured. If the destination tunnel is configured as the
tunnel which must completed the configuration, and it must be configured as GRE tunnel.
Example:
Switch(config)#monitor session 4 destination tunnel 1