PLANET WGSW-52040 - Manual (Page 177)

8-176
information of LLDP function.
Parameters:
None.
Default:
Disable the debug information of LLDP function.
Command Mode:
Admin Mode.
Usage Guide:
When the debug switch is enabled, users can check the receiving and sending of packets and other information.
Example:
Enable the debug switch of LLDP function on the switch.
Switch#debug lldp
8.3 debug lldp packets
Command:
debug lldp packets interface ethernet <IFNAME>
no debug lldp packets interface ethernet <IFNAME>
Function:
Display the message-receiving and message-sending information of LLDP on the port; the no operation of this
command will disable the debug information switch.
Parameters:
None.
Default:
Disable the debug information on the port.
Command Mode:
Admin Mode.