PLANET WGSW-52040 - Manual (Page 367)

20-136
Configures port trust; the no command disables the current trust status of the port.
Parameters:
dscp configures the port to trust DSCP value.
Default:
Trust CoS value.
Command mode:
Port Configuration Mode.
Usage Guide:
trust dscp mode: Set the intp field based dscp-to-intp mapping.
Example:
Set trust dscp of port.
Switch(config)#interface ethernet 1/1
Switch(config-if-ethernet1/1)#mls qos trust dscp
20.14 policy
Command:
Single Bucket Mode:
policy <bits_per_second> <normal_burst_bytes> ({conform-action ACTION | exceed-action ACTION})
Dual Bucket Mode:
policy <bits_per_second> <normal_burst_bytes> [pir <peak_rate_bps>] | <maximum_burst_bytes>
[{conform-action ACTION | exceed-action ACTION | violate-action ACTION }]
ACTION definition:
drop | transmit | set-dscp-transmit <dscp_value> | set-prec-transmit <ip_precedence_value> |
set-cos-transmit <cos_value> | set-internal-priority <inp_value> | set-Drop-Precedence <dp_value>
no policy