PLANET WGSW-52040 - Manual (Page 782)

53-322
Switch(ulpp-group-20)# flush enable arp
53.12 flush enable mac
Command:
flush enable mac
Function:
Enable sending the flush packets of updating MAC address.
Parameter:
None.
Default:
By default, enable sending the flush packets of updating MAC address.
Command mode:
ULPP group configuration mode.
Usage Guide:
If enable this function, when the link is switched, it will actively send the flush packets to notify the upstream device,
so as to update the MAC address table.
Example:
Enable sending the flush packets of updating MAC address.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# flush enable mac
53.13 flush enable mac-vlan
Command:
flush enable mac-vlan
Function:
Enable sending the flush packets of deleting the dynamic unicast mac according to vlan.
Parameter: