PLANET WGSW-52040 - Manual (Page 660)

40-200
Usage Guide:
When configuring the max number of dynamic MAC address allowed by the port, if the number of dynamically learnt
MAC address on the port is already larger than the max number of dynamic MAC address to be set, the extra
dynamic MAC addresses will be deleted. This function is mutually exclusive to functions such as dot1x, MAC binding,
if the functions of dot1x, MAC binding or TRUNK are enabled on the port, this function will not be allowed.
Examples:
Enable the number limitation function of dynamic MAC address in port 1/2 mode, the max number to be set is 20
Switch(config)#interface ethernet 1/2
Switch(Config-If-Ethernet1/2)# switchport mac-address dynamic maximum 20
Disable the number limitation function of dynamic MAC address in port 1/2 mode
Switch(Config-If-Ethernet1/2)#no switchport mac-address dynamic maximum
40.15 switchport mac-address violation
Command:
switchport mac-address violation {protect | shutdown} [recovery <5-3600>]
no switchport mac-address violation
Function:
Set the violation mode of the port, the no command restores the violation mode to protect.
Parameters:
protect: protect mode
shutdown: shutdown mode
recovery: Configure the border port to automatically restore after execute shutdown violation mode
<5-3600>: Recovery time, do not restore by default
Command Mode:
Port mode
Default:
protect mode
Usage Guide:
The port sets the violation mode after enable the number limit function of MAC only. If the violation mode is protect,
the port only disable the dynamic MAC address learning function when the MAC address number of the port exceeds