PLANET WGSW-52040 - Manual (Page 192)

9-191
9.2 interface port-channel
Command:
interface port-channel <port-channel-number>
Function:
Enters the port channel configuration mode
Command mode:
Global Mode
Usage Guide:
On entering aggregated port mode, configuration to GVRP or spanning tree modules will apply to aggregated ports;
if the aggregated port does not exist (i.e., ports have not been aggregated), an error message will be displayed and
configuration will be saved and will be restored until the ports are aggregated. Note such restoration will be
performed only once, if an aggregated group is ungrouped and aggregated again, the initial user configuration will
not be restored. If it is configuration for modules, such as shutdown configuration, then the configuration to current
port will apply to all member ports in the corresponding port group.
Example:
Entering configuration mode for port-channel 1.
Switch(config)#interface port-channel 1
Switch(Config-If-Port-Channel1)#
9.3 lacp port-priority
Command:
lacp port-priority <port-priority>
no lacp port-priority
Function:
Set the port priority of LACP protocol.
Parameters:
<port-priority>: the port priority of LACP protocol, the range from 0 to 65535.
Command mode:
Port Mode.