PLANET WGSW-52040 - Manual (Page 188)

8-187
LLDP enabled port : Ethernet 1/1
LLDP interval :30
LLDP txTTL :120
LLDP txShutdownWhile :2
LLDP NotificationInterval :5
LLDP txDelay :20
-------------END------------------
8.17 show lldp interface ethernet
Command:
show lldp interface ethernet <IFNAME>
Function:
Display the configuration information of LLDP on the port, such as: the working state of LLDP Agent.
Parameters:
<IFNAME>: Interface name.
Default:
Do not display the configuration information of LLDP on the port.
Command Mode:
Admin Mode, Global Mode.
Usage Guide:
Users can check the configuration information of LLDP on the port by using “show lldp interface ethernet XXX”.
Example:
Check the configuration information of LLDP on the port after LLDP is enabled on the switch.
Switch(config)#show lldp interface ethernet 1/1
Port name : ethernet 1/1
LLDP Agent Adminstatus: Both
LLDP Operation TLV: portDecs sysName sysDesc sysCap
LLDP Trap Status: disable
LLDP maxRemote: 100
LLDP Overflow handle: discard
LLDP interface remote status : Full