PLANET WGSW-52040 - Manual (Page 260)

17-29
Function:
Specify a port to enable selective QinQ, the no command restores the default value.
Parameter:
None.
Command Mode:
Port mode
Default:
Do not enable selective QinQ.
Usage Guide:
Enable selective QinQ command should associates with hybrid mode, and it should not be used with dot1q-tunnel
enable synchronously.
Example:
Enable dot1q-tunnel selective enable of port1.
Switch#config
Switch(config)#interface ethernet 1/1
Switch(Config-If-Ethernet1/1)#dot1q-tunnel selective enable
17.1.5 dot1q-tunnel selective s-vlan
Command:
dot1q-tunnel selective s-vlan <s-vlan> c-vlan <c-vid-list>
no dot1q-tunnel selective s-vlan <s-vlan> c-vlan <c-vid-list>
Function:
Add the mapping relation between user’s VLAN ID list and SP VLAN ID for selective QinQ, the no command
deletes the mapping.
Parameters:
s-vlan is SP VLAN ID, c-vid-list is the range of user’s VLAN ID.
Command Mode: