PLANET WGSW-52040 - Manual (Page 807)

56-347
<length-value> is the value of the length with a valid range of 32-256.
Command Mode:
Port Mode.
Default:
128 by default.
Usage Guide: If the packet sample can not be identified whether it is IPv4 or IPv6 when sent to the CPU, certain length of
the head of the group has to be copied to the sFlow packet and sent out. The length of the copied content is configured by
this command.
Example: Configure the length of the packet data head copied in the sFlow data sampling to 50.
Switch(Config-If-Ethernet1/2)#sflow header-len 50
56.7 sflow priority
Command: sflow priority <priority-value>
no sflow priority
Function:
Configure the priority when sFlow receives packet from the hardware. The "no” form of the command restores the
default.
Parameter:
<priority-value> is the priority value with a valid range of 0-3.
Command Mode:
Global Mode.
Default:
The default value is 0.
Usage Guide:
When sample packet is sent to the CPU, it is recommended not to assign high priority for the packet so that regular
receiving and sending of other protocol packet will not be interfered. The higher the priority value is set, the higher its
priority will be.
Example:
Configure the priority when sFlow receives packet from the hardware at global mode.