PLANET WGSW-52040 - Manual (Page 775)

53-315
Parameter:
<integer> is the control VLAN ID that sends the flush packets, range from 1 to 4094.
Default:
The default is VLAN 1.
Command mode:
ULPP group configuration mode.
Usage Guide:
Configure the control VLAN of ULPP group. This VLAN must correspond the existent VLAN, after it is configured,
this VLAN can’t be deleted. It must belong to the VLAN protected by ULPP group to avoid flush packets loopback.
Example:
Configure the sending control VLAN of ULPP group as 10.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)# control vlan 10
53.3 debug ulpp error
Command:
debug ulpp error
no debug ulpp error
Function:
Show the error information of ULPP. The no operation disables showing the error information of ULPP.
Parameter:
None.
Default:
Do not display.
Command mode:
Admin mode.
Usage Guide: